TallyGenicom 2265+, Руководство пользователя

Страница: 43 / 186

User guide The control panel
33
Messages in the LC
display
If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g.
Initializing ). Below you
will find a list of messages with brief descriptions of each message.
The messages are described in greater detail in the chapter
Error
messages via the display (page 114).
Message Meaning
Eject error
The printer cannot eject the paper/
advance it to park position.
Hardware Alarm
Internal hardware error, contact your dea-
ler or service technician.
Initializing
This message appears during the prin-
ter’s initializing phase after switching on
the printer.
Load error
The printer cannot draw in the loaded
paper.
Load paper from
The printer has detected paper end
during operation/printer was switched on
with no paper loaded.
Loading default
Factory defined parameters will be
reloaded in all available menues after
switching on the printer.
Out of paper
The printer has detected paper end
during operation / printer was switched on
with no paper loaded.
Paperwidth error
Print characters override the detected
right paper margin.
Parity error
A parity error during data transmission is
indicated.
Park position
Printer was switched on with no paper
loaded.
Press any key
The user is requested to press any key.
PW sensor defect The automatic paper width detection
cannot detect the left paper margin.
Selftest
After power-on, the printer executes a
short hardware self-test.
Tear Paper off
The user is requested to tear off paper
which has been advanced to the tear
edge.