Tally T2265 SprintPro, Руководство по обслуживанию

Страница: 68 / 178

4.2.2
Further Messages
in the LCD Display
The messages in the table below are not error messages, but operating steps to be
mentioned.
Message Meaning
Head Hot The printhead is hot.
The printer reports that the temperature of the
printhead is becoming too high and that print speed
is being reduced for this reason.
Head Hot (permanently
displayed) Try to adjust head temperature (T2170 only, see
section 6.3.1)
Check printhead; if damaged please replace
printhead (see section 5.2)
Replace printhead cables
Replace main board
Insert Paper Top or Front Paper is not available in selected paper way. Data is
in interface receive buffer.
Loading Default Printer is loading default (factory) configuration. It is
possible to do this manually by pressing the four
function and selection buttons when turning on the
printer (see also Reference Manual on CD-ROM).
Default anyway is loaded after installing different or
new firmware.
Only Available in EPSON
Mode Functions which are not meaningfull in this emulation
have been selected. To use the selected feature you
have to switch over the emulation to Epson.
Open Front Flap If you have choosen “the single sheet feed” then you
must open the front flap.
Park Position You are informed when the fanfold paper is in park
position.
Please Wait Your printer is occupied with internal proceedings.
Press any Key You are requested to press any key.
Remove Paper in xxx The paper way is changed (xxx indicates the paper
way). Remove the remaining paper in the printer
manually.
Tear Paper Off Note for the operator to tear off the paper positioned
on the tear off edge before.
Adjust Tear or Adjust Cut Use this keys
↑ ↓
or ,,>“, ,,<“ to adjust the paper at
tear position (valid also for Cut feature).
Troubleshooting Testmodes and Troubleshooting
4-6