Tally T2265 SprintPro, Руководство по обслуживанию

Страница: 167 / 178

11 Cutting Device (Option)
Safety notes:
– If you have any short pieces of paper remaining in the device, turn off the printer
first.
– Do not stick unsuitable materials or tools – such as screw drivers etc. – into the
device openings as this may damage the mechanical system.
– Replace the protective cap for the drive wheel at the printer when the cutter is no
longer needed (in use) to prevent long hair, chains etc. from being pulled into the
printer.
11.1
Specifications
Cut width 400 mm
Cut height min. form length 2.5 inches (6.35 cm)
Cut time 1000 ms
±
10%
Specification of
recommende forms Only continous forms in printer tractors can be cut
Cutting accuracy Single forms and two part forms
±
1 mm
Other forms
±
2 mm
depending on the stiffness of the cross perforation
Service life >1.000.000 cuts
Weight approx. 4 kp
Paper type fanfold paper
Paper weight Single form: 60 g/m
2
– 120 g/m
2
Multi-part form (Main tractor):
Original 45 g/m
2
– 120 g/m
2
1st sheet 45 g/m
2
– 65 g/m
2
Copies 45 g/m
2
– 56 g/m
2
Last sheet 45 g/m
2
– 65 g/m
2
Total <280 g/m
2
Multi-part form (Rear tractor):
1st sheet 45 g/m
2
– 65 g/m
2
1st copy 45 g/m
2
– 56 g/m
2
2st copy 45 g/m
2
– 56 g/m
2
Copies 1. push tractor 1 + 6
2. push tractor 1 + 1 (depending on paper
quality)
Stacker 1 sheet-sets >150 sheets 80 g/m
2
6 sheet-sets >50 sets
multi-part depends on crimping (punch printing on edge of
sheet) and perforation/paper weight
Paper stacking, above all of multi-part sets, depends on
the quality of the crimping
For all further data and specifications, please refer to your printer’s standard
operator’s manual or the operator’s manual “Cutting Device”.
Specifications Cutting Device (Option)
11-1