WEBS-CM-2 Communications Module
Quick Installation Guide
Page
6
of
6
Rev. 2/4/14
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
X.
Line Level Audio
Connect the Line Level Audio connector on the PCB as shown in the
Figure 2
, to the respective device
on the other end, such as the WEBS
®
paging amplifier, recording device, speaker, etc.
XI.
Final Assembly
After completing the field wiring installation, fasten the enclosure cover on the enclosure with the four
(4), #6-32 Phillips head screws.
NOTE:
It is the installer’s obligation to ensure that the wiring should pass through the cable entry hole
at the bottom of the enclosure. Please exercise caution when reinstalling the enclosure cover and
ensure that no cables are crushed during the process.
Install the
WEBS-CM-2 Communication Module
into its appropriate mount (e.g.
WEBS-MT/R
, as
shown in
Figure 7
), with four (4) #6-32 Phillips head screws.
Figure 7
- Installation of a WEBS-CM-2