WEBS-CM-2 Communications Module
Quick Installation Guide
Page
3
of
6
Rev. 2/4/14
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
IV.
Network Connectivity
The
WEBS-CM-2
is equipped with two (2) Ethernet ports. The WAN Ethernet (PoE) port should be
used as the primary port for data communications. The WAN Ethernet port can be used to power the
phone via an IEEE 802.3af, Class 3 compliant PoE supply.
The
WEBS-CM-2
has a layer 2 switchport labeled LAN Ethernet which can provide network
connectivity to an auxiliary device e.g. (IP Camera, Card Reader, etc). The LAN Ethernet port is a pass-
through port and cannot be used to access the phone.
When installing the Network cable, it is essential to have a ferrite core (provided with the unit), installed
on to the cable as close as possible to the connector. Make sure the network cable is passed twice
through the ferrite core, forming a loop of not less than one (1) inch in diameter.
A cable with a rating of Cat5e or higher with an RJ45 connector is typical for all network cables.
Figure 4
- Installation of the ferrite core on the network cable
V.
Power Requirements
The
WEBS-CM-2
can be powered over Ethernet or through a dedicated, line-regulated power supply
that meets the following specifications:
Power Input
Description
Acceptable Voltage Power Consumption
Ethernet WAN
PoE
– IEEE 802.3af Class 3 +36-57 VDC
150 mA
Power Supply Input 12 VDC
+10-14 VDC
500-800 mA
Power Supply Input 24 VDC
+21-27 VDC
300-500 mA
Power Supply Input 24 VAC
+21-27 VAC
300-500 mA
