EC-6
Installation and Operation Manual
Page
7
of
10
Rev. 08/24/2023
Copyright 2020-2023 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, and WEBS are registered trademarks of Talk-A-Phone, LLC. All rights reserved. All other
trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement, sponsorship, or affiliation with such
owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
3.9. Hang Up (##7)
When programming the
EC-6
from a remote location, this command can be used to cause an
immediate hang up. This is useful if the
EC-6
is being used on a phone line that does not issue a CPC
signal when the distant party hangs up. In those cases, and if the
##
7 command is not used, the
EC-6
will still hang up, but after the programming time out of 20 seconds.
3.10. Factory Reset All Programming (###)
When in programming, entering
###
will reset all programming to the factory default settings.
Switch
Position
Description
1
ON
Emergency phones must dial 9 to connect to the telephone line (see
description below)
1
OFF
Emergency phones are directly connected to the phone line (factory
setting)
2
ON
Enable Line Verification test (see description in
Section 3.11,
Operation
)
2
OFF
Disable Line Verification test (factory setting)
3
ON
Learn mode (see description below)
3
OFF
Normal operation (factory setting)
Switch 4
Switch 5
Description
ON
ON
Normal audio detect sensitivity (factory setting)
OFF
OFF
Increased audio detect sensitivity. Useful in applications in which voices
or busy signals are having trouble breaking over the speaker when
multiple Emergency Phones are in use at the same time.
