WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page
25
of
53
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected]• www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Firmware upgrade initiated. Do not reboot...
: The firmware upgrade has been initiated; the
firmware upgrade request is processed only when communications module is in an idle state. For
example, a call is in progress and administrator requests for a firmware upgrade through the W eb
GUI. The communications module checks for an active call every five seconds and starts the process
once the active call is terminated.
The following are considered to be idle communications module states: no active call, no dialing, no
voice message is being played, and the Auxiliary Output is deactivated.
Firmware upgrade in progress. Do not reboot...
: The firmware upgrade is in progress. The process
generally takes around 1-2 min to complete.
Firmware upgrade done. Going to reboot...
: The firmware upgrade is complete and a reboot has
been initiated. After approximately one minute, the communications module will be accessible once
again.
4.7.7. SMTP Server Configuration
The SMTP Server Configuration page is used to configure the mail settings for email notifications.
Login → Maintenance → SMTP Server Configuration
Figure 29 SMTP Server Configuration
To setup SMTP:
1.
Check the
Enable SMTP
check box.
2.
Enter the
SMTP Address
and
Port
where emails should be sent.
3.
Click
Apply
to save settings.
3
1
2
