TALEX Spółka z ograniczoną odpowiedzialnością Sp. K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26
by email.
The Instruction Manual
LEO 320 PROFESSIONAL shredder
Page
6
of
37
securing the vehicle from rolling down. The shredder must be lowered to the ground.
Put wedges under the wheels of the vehicle.
The shredder must be adjusted to working height, during its attachment to the vehicle.
Setting adjustment is possible during the shredder operation which should be done from
the inside of vehicle cabin, with the operator remaining in the cabin.
Any preparations, fitting, dismantling or adjustment can be performed only after the
drive has been switched off, the engine stopped, the vehicle immobilized
and when all the moving parts of the machine have stopped.
After the first hour of operation, check all disjoint connections, i.a. screw
connections.
The shredder should be kept on a flat, level, paved surface,
out of the reach of strangers and animals. Use the support foot for stabilizing the
shredder.
Exercise caution during the mounting and dismounting of the shredder, and pay
particular attention to the structural elements through which the cutter is connected
with the vehicle.
Prior to commencing work, check the technical condition of the shredder
and the vehicle it is attached to. The vehicle and the shredder unit must be in good
technical condition. Worn or damaged parts must be replaced immediately.
The shredder must be equipped with all the safety guards (provided by the
manufacturer), preventing access to any moving parts. The guards must be
complete and fully operational.
Before beginning to work with the shredder, familiarize yourself with the way it
operates, occupational safety rules and recommendations for maintenance and
adjustment procedures, by reading this instruction manual.
The weight of the shredder mounted on the vehicle may affect the manoeuvrability. In
this situation, particular caution should be exercised.
The instruction manual should be kept on the machine. When letting the machine to other
user, you must ensure that it is in good mechanical condition, and that the instruction
manual is also handed over.
Do not attach additional transport means to the shredder.
By first start, check operation of the machine, and make the initial adjustment
without load.
TUZ (three-point hitch suspension system) assembly protection of the shredder with
pins should be made only using the typical secure cotter pins. Do not use other
securing elements.
