STEP 4
Ensure the bulb is screwed in fully
and contact is made between the
base of the bulb and the housing,
without overtightening.
The bulb and housing are both
safe to touch.
IMPORTANT
Over-tightening or under-tightening
of the bulb will cause misaligment.
If this occurs, make small
adjustments until straight and just
touching the contact point.
Contact point
STEP 3
Remove bulb from box and carefully
screw into the lampholder coil by
turning the bulb clockwise.
Be careful to align the bulb properly
and do not over-tighten.
The glass can be removed again after
initial installation for better access to
bulb and lampholder coil.
