TAKTL
®
Field Guide | Drilling for Concealed Fasteners
Doc. P10-1 Rev. 1708
WWW.TAKTL-LLC.COM | 412.486.1600 | info
@
taktl-llc.com
TAKTL
®
Field Guide | Drilling for Concealed Fasteners | 7 of 8
E
05 Attaching New Bit
Place the new drill bit over the
mounting pin and align the set
pin holes with the recesses in the
mounting pin.
Insert the set pins into the shaft of
the drill bit, making sure they seat
firmly in place
(FIG. E)
.
F
06 Re-attaching Black O-ring
Roll the black O-ring over the shaft
so that it seats into the notches on
the heads of the set pins
(FIG. F)
.
G
07 Test
Turn the drill upright and gently
push the side toggle lever down. If
the toggle does not move, remove
the O-ring and set pins, turn the
drill bit 180 degrees and reinstall
the pins and O-ring. Over time, the
black gasket around the base of the
drill may begin to wear
(FIG. G)
.
H
08 Removing Faulty Gasket
Pull the gasket out of the groove
around the base of the machine
and secure a new one into place. It
may have to be worked a bit to seat
completely into the groove
(FIG. H)
.
