Accessories
Tapping screw
φ
4×30
: 2 pcs
Instruction
Manual
: 1 pc
WIRING HOLE (KNOCKOUT)
CORNER MOUNTING HOLE
(4 CORNERS)
(KNOCKOUT)
TAMPER SWITCH
REFLECTOR FOR
CREEP ZONE
MODE SELECTOR
INNER UNIT
(5 POSITIONS
ADJUSTMENT)
AREA LOCK HOLE
(TO BE SCREWED)
WALL MOUNTING
HOLE
(KNOCKOUT)
WALL MOUNTING
HOLE (KNOCKOUT)
WIRING HOLE
(KNOCKOUT)
BASE
COVER
COVER LOCKING
SCREW
LENS
PASSIVE INFRARED SENSOR
Instruction Manual
1
PRODUCT DESCRIPTION
Warning
2
PRECAUTIONS
This manual describes precautions by classifying them based on degrees of danger and
damage that would be generated if using the unit incorrectly.
Be sure to observe
We categorize these precautions throughout the manual using the following symbols.
Warning
Caution
This indicates the possibility of severe injury, and
even death, if ignored or a user handles the unit
incorrectly.
This indicates the possibility of minor injury and/or
damage to properties, or of a notification delay in your
system due to false operations and/or non-detection, if
ignored or a user handles the unit incorrectly.
An action you must do, and information you should keep in mind.
A prohibited action, you must not do.
Do not disassemble or modify this device. This may cause a fire,
electrical shock, or malfunction of the device.
If the following events occur, turn off the power of the unit
immediately, and ask the place of purchase for repair. Failure to
follow this may result in fire, electric shock, and/or malfunction.
• Smoke, abnormal odor, and/or sound are found
• Liquid, such as water, and/or foreign material has entered the unit
• The unit has deformed and/or damaged parts
Do not install this device in a location that cannot support its weight.
This may lead the device to fall and cause an injury or malfunction
of the device.
Mount the unit on solid ceilings or wall surfaces where reinforcement
materials are used. If you mount the unit on non-wood materials such
as plaster board or concrete, securely mount it using anchors and
mounting screws that match the wall materials. Unstable mounting
may result in injury and/or property damage if the unit falls.
Do not connect devices that exceed the indicated capacity to the
output contact of the unit. Failure to follow this may result in electric
shock, fire, and/or malfunction.
Do not touch terminals with wet hands. Failure to follow this may
result in electric shock.
Do not use the unit with power voltage levels other than those
specified. Failure to follow this may result in fire, electric shock, and/or
malfunction.
Thank you for purchasing this product. Before using the products, please read this instruction manual carefully to ensure correct operation.
Caution
Do not apply impact to the unit.
Strong impact may result in performance deterioration and/or
damage to the unit.
The unit may not operate properly near devices that generate a
strong electric or magnetic field.
Also, devices near the unit may not operate properly due to the
magnetic field and/or magnetism generated from the unit.
Make sure to confirm before operation.
Make sure to perform a sufficient operation check on the whole
system before operation.
Refer to the detection area chart, and select the installation location.
Then, check the actual operation, and adjust the appropriate area.
Make sure to check operation when you move tables and partitions
to change the layout in protected rooms.
Do not install the unit in places subject to oil, smoke, steam, high
humidity, and/or a lot of dust.
Electricity that is conducted through these substances may result in
fire, electric shock, and/or false operation.
PA-480S
ALARM LED
ALARM LED
WIRING CAHANNEL
Area lock screw
φ
3×10
: 1 pc
