FUNCTION
4
⑥
(Cover tamper)
Back tamper
knockout
Back tamper
rubber
After turning the power ON, the operation LED will blink for approximately 1 minute.
During this time, the device is stabilizing, and will not operate.
If the cover is removed, or if it is incorrectly mounted, a tamper alarm is output and
a warning given.
In this condition, if the cover is then attached correctly, then output is stopped.
When the tamper alarm is issued, immediately check the sensor operation and
installation.
When the back tamper knockout is broken, ensure that the back tamper rubber is attached.
Additionally, when mounting, take care that the back tamper rubber is not broken.
(Sensor mounting status monitoring): Default is disabled
The back tamper rubber should be mounted to activate the function.
If the sensor is removed, or if it is incorrectly mounted, a tamper alarm is output
and a warning given.
In this condition, if the sensor is then attached correctly, then output is stopped.
When the tamper alarm is generated, immediately check the sensor operation and
installation. (The sensor cannot differentiate between cover and sensor tampering)
＊
Back tamper rubber cover installation procedure
Move the knockout tab on the rear of the sensor left
and right, and twist off. Attach the back tamper
rubber. (Take care with the mounting direction.)
Additionally, after attachment, ensure that
operation is checked.
Wake-up
: blinking (approx. 1 minute)
Sensor detection
: ON (synchronize to an alarm output)
Sensor trouble
: ON (continues until resolved)
Low in power supply voltage
: blinking (continues until resolved)
＊
LED (only for sensor detection) can be disabled
by the settings switch.
WARM UP
OPERATION LED (RED)
TAMPER
BACK TAMPER
A function that detects and notifies the user of problems resulting from issues such as broken wiring within the sensor.
This generate a continuous alarm in the event of a sensor malfunction.
This also notifies the user of the malfunction by continuously lighting the operation LED. If a malfunction occurs,
immediately check the sensor.
SENSOR TROUBLE DETECTION FUNCTION
A function that monitors the input power supply voltage to the sensor, and if a reduction is detected, notifies the user.
This issues a continuous alarm in the event of a reduction in power supply voltage. This also notifies the user of the
malfunction by continuously flashing the operation LED. If a malfunction occurs, immediately check the power source
and the sensor.
POWER SUPPLY VOLTAGE MONITORING FUNCTION
→
[
5
SETTING]
1
ON
OFF
