Takeuchi TB28FR, Руководство оператора

Страница: 126 / 182

124
MAINTENANCE
Every 1000 Hours
6. Run the engine at a low idle for about 30
minutes. For the first 5 minutes after
starting it, pay attention to the level of the
cleaning fluid, and add tap water if the level
drops.
7. Stop the engine and drain the cleaning
fluid.
8. Tighten the drain plug (4), add tap water,
run the engine at a low idle for about 10
minutes, then stop the engine and drain
the water.
Clean repeatedly until the drained water
is clear.
9. After cleaning is completed, tighten the
drain plug (4) and add new coolant up to
the specified level.
10. Run the engine at a low idle, bleed the
air, then stop the engine once the coolant
level stabilizes at the specified level.
11. Check the coolant level, then tighten the
radiator cap (3).
12. Clean the inside of the reserve tank (1),
then add coolant up to the upper limit (H).
Replacing the Air Cleaner Element
Stop the engine and allow the machine
t o c o o l d o w n b e f o r e p e r f o r m i n g
maintenance.
¡
The engine, muffler, radiator and many
other parts of the machine are hot
directly after the engine is stopped.
Touching these parts will cause burns.
IMPORTANT: Do not use an element if its
flutes, gaskets or seals are damaged.
1. Open the engine hood.
2. Loosen the clamp (1) and remove the dust
cup (2).
3. Clean the inside of the dust cup (2).
4. Remove the element (3).
5. Cover the intake hole at the back of the
body (4) with cloth or tape to prevent dirt
from getting in.
6. Clean the inside of the body (4).
7. Remove the cloth or tape applied in step
5.
8. Install the new element.
9.Install the dust cup (2) with the “TOP” mark
at the top, then fasten it with the clamp
(1).
WARNING
F4G011
1
2
3
4