26.2.2021
.
05-05-0045
7 /
7
Installation instructions *Refer to the factory service manual for installation instructions and specified torques for details not specifically
mentioned.
How to operate
Meter start-up and maximum RPM check
The meter is activated by key ON.
When the select button (S button) is pressed, the red LED blinks and the pointer
points to the maximum RPM. At this point, the maximum RPM can be erased by
holding down the S button for 3 seconds.
● Press S again to return to normal mode
.
ADJ Mode.
● Adjust
button
(A button)
A S
back
● Select
button
(S button)
Enter ADJ mode by pressing the S and A buttons simultaneously for more than 3 seconds.
setpoint (e.g. of a
function or relation)
1 Lev alarm
LED Lighted RPM
0 - 15000 pm Unit: 500 rpm
8000 - 9000 rpm
(recommended)
2 RPM Signal frequency Number of signals per 2 crankshaft revolutions 1 - 4 Signal
1
3 RPM Signal type
setting
Type of loading programme
1: Hi mode, 0: Lo mode.
1: Hi mode.
Turn the key to ON and switch the meter on.
Press the S and A buttons simultaneously for more than 3
seconds to enter ADJ mode.
1
Rev alarm settings
lighting (a lamp)
front of a dial
flashing
S button
flas
hing
lighting (a lamp)
S button
flash
ing
flashing
S button
During running, the red LED lights up when the set
speed is reached.
2
RPM Signal frequency setting
●
Selectable from 1 to 4 signals.
Each time the A button is pressed, the pointer
moves.
Check that the pointer points to 1 and press S
to continue.
3
RPM Signal type setting
●
Selectable from 1 or 0.
Each time the A button is pressed, the pointer
moves.
Check that the pointer points to 1 and press S
to exit ADJ mode.
●
S button
proceed
to the
next
paragrap
h
●
A
Button
adjustm
ent
Exit ADJ mode.
Range: 1 for Hi mode, 0 for Lo mode.
Type of loading programme
Range: 1 - 4 Signals.
Number of signals per 2 crankshaft
revolutions
Range: 0 - 15000
rpm Unit: 500 rpm
LED Lighted RPM
