17
Close
Open
Tap
Shower Head Plate
Low-splash mode
water outlet
<Shower Mode>
<Low-splash Mode>
・
Press the switch on the side
with the protrusion.
・
Press the switch on the flat side.
Protrusion
Depression
Water Outlet
Shower head holder
■
Adjusting the volume of water
(excluding AY-P073X,AY-074X)
A left (counterclockwise) rotation of the tap
increases the amount of hot water.
A full left (counterclockwise) rotation of the knob will
output the maximum amount.
A full right (clockwise) rotation of the knob will stop the
water.
Caution
Caution
When the basin is not being used, turn the tap firmly full right (clockwise) to
turn the water off properly.
Failure to do this may cause water leakage.
After shampooing, do not cover the drain with the drain cap, towel or shampoo cloth as hot
water may come out. Hot water that is accidentally trickle due to an increase in water
pressure at night. This may cause water to spill from the basin, leading to water leakage.
If the drainage become sluggish, the drainpipe may be clogged with dirt. Discontinue use and
contact with your closest dealer.
A gushing sound may be emitted from the main body depending on the environment or conditions
that it is used in. This sound is due to water flowing fast through pipes as a result of high water
pressure or water volume control, and is not indicative of a defective product. This gushing sound can
be reduced by adjusting the water pressure.
The tap may become stiffer when turned depending on the environment or condition
that it is used in. This is due to deterioration of gasket of movable parts or a lack of grease as a
result of aging. Replacement of the gasket or other parts, or a recoating of grease is required.
Note
■
Using the Dual Function Shower Head
Changing the selection switch position switches between Shower Mode and Low-splash Mode.
Selection Switch
Protrusion
Shower head
Do not discharge a strong water stream when the
shower head is in the shower head receptacle.
Failure to take this precaution may result in system failure
due to spilled water or damage to the floor.
After using the shower head, be sure to put it back in the
shower head receptacle. Place it back into the receptacle
so that the protrusion on the shower head matches the
recessed portion on the receptacle.
