Rotate and loosen the air bubble fixture with the wrench.
2
Loosening
Tightening
Remove the three parts (rubber gasket, air bubble unit, and
air bubble fixture) and wash with water using a nylon or
similar brush.
3
Running Water
Air Bubble Unit
The air bubble unit should be rinsed with running water
in the direction shown in the illustration below:
Running Water
Air Bubble Unit
After cleaning, set the three parts in the order shown in the
illustration.
Tighten the air bubble fixture with the wrench.
This completes the cleaning.
5
4
Rubber Gasket
Air Bubble Fixture
Air Bubble Unit
19
<Spa Showerhead>
1
Rotate and detach the sprinkling filter unit and remove the
three parts (sprinkling filter unit, air bubble unit, and rubber
gasket).
(*Do not detach the O-ring.)
2
Clean the sprinkling filter unit (with water).
Remove dirt, such as water deposits in the shower holes
on the sprinkling filter unit, with a toothbrush.
3
Clean the air bubble unit (with water).
Clean the unit once a month (as a general guide).
Remove dirt, such as water deposits on the air bubble
unit, with a toothbrush.
Sprinkling Filter unit
Air Bubble Unit
Rubber Gasket
O-ring
Showerhead Main Unit
The air bubble unit should be rinsed with running water
in the direction shown in the illustration below:
Surface to be Cleaned
(front and back)
4
Re-assemble the showerhead.
<Assembling Procedures>
(1) Insert the air bubble unit and the rubber gasket in
the sprinkling filter unit in this order.
(2) Mount the sprinkling filter unit on the showerhead
main unit, while the water discharge side of the
sprinkling filter unit facing down.
1.
2.
Water Discharge Side
The air bubble unit and the gasket can be reused after washing
with water. If replacements are required due to deterioration or
breakage, however, contact your closest dealer.
