Care and Maintenance
Caution
Take care of the product after use and keep it always clean. If dirt is allowed to remain, mold may
be generated.
Maintenance of each section
To use the equipment that has not been used for a long time, clean before using and be sure to
check that the equipment operates safely without any error.
Metal
If the dirt is heavy
Wipe the upholstery with soft and dry cloth.
Upholstery
Resin
By using a soft cloth dampened with neutral
detergent diluted to about one tenth with water,
wipe out dirt. After that, wipe with a dry cloth.
If the dirt is heavy
Wipe the resin with soft and dry cloth.
By using a soft cloth dampened with neutral
detergent diluted to about one tenth with water,
wipe out dirt. After that, wipe with a dry cloth.
Wipe the metal with soft and dry cloth.
Do not wipe the metal with wet cloth because the metal hates humidity and water. If the metal
is watered, wipe out moisture immediately. Moisture may cause rusting or malfunction.
Do not use anything other than neutral detergent for cleaning.
· Particularly, never use the following:
Volatile chemicals such as thinner, alcohol, nail polish remover, gasoline, or
kerosene; acidic, alkaline and chlorinated detergent; strong disinfectant that
corrodes metal; povidone-iodine (isodine solution); sodium hypochlorite; abrasive
wax; abrasive sponges, etc. Do not use a brush or scrubbing brush for cleaning.
It may scratch the surface, making it impossible to remove dirt.
· The metal and mechanical parts of the equipment have sharp portions. Be
careful not to hurt your hands or fingers at the time of cleaning.
· Do not clean the upholstery with detergent including organic solvent or abrasives
or bleach. Doing so may cause deterioration of the surface and change of
texture and gloss.
· In order to avoid infiltration by plasticizer when the color of clothing or a belt
remains in the upholstery, wipe it out by using a soft cloth dampened with neutral
detergent diluted to about one tenth with water. After that, wipe with a dry cloth.
Spray-type (especially hard type) hair-setting agent
When using a spray-type hair setting agent (especially hard type), check that the hair setting agent
does not adhere to the exterior surface (including the leather part) of the entire product. If it is
adhered to, wipe it off immediately. If you leave it as it is, the hair plating agent will become sticky,
leaving behind a rough feeling, and the rough feeling will become noticeable especially in the flat part
such as the resin cover.
Note: Action to be taken when the hair setting agent has become hard
If the hair setting agent sticks on, remove it with ethanol.
However, if you remove the adhered agent repeatedly with alcohol, the surface will deteriorate
causing the coating to come off, leading to loss of brightness, cracks, etc.
Wiping quickly when the hair setting agent adheres will be the best prevention.
11
Содержание Koken 90
Страница 15: ...NOTE...
