Takara Belmont AY-ELI, Руководство по эксплуатации

Страница: 20 / 28

Caution
The water in the trap serves to prevent
odors from sewage water.
Be sure to add some water to the trap
after cleaning.
Drain the water from the trap and clean the trap.
After draining the water and cleaning the trap by
removing dust and dirt, tighten the drain part firmly.
Note
According to the instractions of trap used,please care.
Note
The "Parts Replaced on a Regular Basis" described on page 26 must be replaced on a regular basis
to ensure and maintain safety and performance. Any part that is outside the designated replacement
period must be replaced even if there is no problem during use. Our company will not assume
responsibility for any harm, damage, or defects attributed to the fact that a part was not replaced
within the designated period.
Close the hot water and water stop valves.
Caution
To prevent water leakage, always check
that the stop valves are completely closed
before cleaning or draining the water from
the strainer.
After checking that the strainers have been fastened properly,
open the stop valves.
Check that there are no water leaks from the check valve.
Mount the maintenance cover onto the main unit.
The maintenance cover can be mounted by hooking the
three latches on the main unit. First, hook the top latch and
then hook the bottom two latches.
Caution
Check that the maintenance cover is properly
secured with the three latches. If not, water
may penetrate the main unit resulting in
system failure.
Clean the strainer.
When the strainer is detached, the water in the pipe will come
out. Therefore, rotate and detach the strainers of the check
valves for hot water and water, while catching the water in a
container. After completely draining the water from the check
valve, clean the strainer by removing dust and dirt, set it in
the original position, and tighten firmly.
(Tool required: a blade-head screwdriver)
Caution
Removing the strainer from the hot water
supply pipe may cause hot water to spill out.
Take extra care when draining the hot water.
The drain nut and strainer should be
tightened firmly. If they are not, there is a
possibility of water leaks.
If the drain water spills onto the floor,
immediately wipe it up.
Latch
Latch
Latch
Check Valve
Stop Valve
Strainer
Detach
Attach
Loosen
Tighten