26
Page
Installation
Installation Manual
Fig. B
Back plate
3-1/4 inches
Attach the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout
Only the outdoor model comes with the temperature remote controller
Check that these items below are included with the remote controller
Temperature
Remote Controller*
Screws
Manual
Remote Controller Cable
Qty: 1
Qty: 1
Qty: 2
Qty: 1
TEMPERATURE REMOTE CONTROLLER
-INSTALLATION-
<Mounting and Wiring the Remote Controller>
1.
Take off the “
Back plate
” from the remote controller with a flat head screwdriver
(Fig. A and B)
2.
Attach the “
Back plate
” on the wall with the two provided screws
(Fig. B)
•
This remote controller is NOT waterproof
Do not install in high temperature environments, steamy conditions (such as a
bathroom), outdoors, in direct sunlight, or within the reach of children
Make sure the remote controller does not come into contact with water or oil
•
Do not place the remote control wiring close to other wires from other
products
•
Do not extend the remote control wiring more than 400 ft (122 m)
CAUTION
9009069005/TM-RE42
*It is also an optional accessary as a second remote for the indoor model Refer to p 32
