16
CONNECTION OF REMOTE CONTROLLER WIRING TO THE WATER HEATER
1. Turn off the power supply to the water heater.
2. Remove the front cover from the water heater. There are 3 screws on the front cover.
3. Put the remote control wires through the hole on the bottom of the unit’s casing.
4. Connect the remote control wires to the remote terminals directly. (There is no polarity in the
terminations.)
*DO NOT jump or short-circuit wires as it will damage the computer.
5. Replace the front cover. Then connect the power plug.
REMOTE CONTROLLER – CABLE CONNECTIONS
Remote control wires
Remote control terminals
Put the remote control wires
through the hole on the bottom of
the unit’s casing.
TYPICAL CABLE LAYOUT
MC-110-AU FC-110-AU
SC-110-AU
