TAJIMA TEHX-C, Руководство пользователя

Страница: 114 / 140

CHAPTER 11 TROUBLESHOOTING
107
2BB Available range to perform frame back was exceeded. Do not perform frame back any more.
2BC No design is registered in the memory. Register designs in the memory.
2C2 Incorrect option setting Set correctly.
2C6
Machine operation was attempted although the bobbin
changer was running. Do not operate the machine during working of the bobbin
changer.
2CB
The design data is too big to be put in the set embroi-
dery space.
Change to smaller design data.
2CC A floppy disk was inserted during operation. Take out the floppy disk.
2CE Stop by safety device Check safety, and remove the obstacle.
2E3
The power supply was shut off during operation
(including power shut off by the emergency switch).
Execute power resume operation.
311
Encoder A signal does not change for 5 seconds.
Abnormality of motor, motor belt
Check encoder or encoder signal lines.
Check the motor or motor belt.
Check the main shaft driver for excitation.
312 Encoder Z signal status does not change. Check the encoder or encoder signal lines.
316 A main shaft driver error signal has been detected. Replace the main shaft driver unit or main shaft motor.
322 An X-axis motor driver error signal is detected. Replace the X-axis driver.
323 An Y-axis motor driver error signal is detected. Replace the Y-axis driver.
331 Bobbin changer error
Operate the bobbin changer manually to check the place where
movements are bad, and adjust it.
382
The needle position signal status during color change
does not change for 1 second or more.
Check the color change motor and power supply circuit.
Check the potentiometer (needle position sensor).
383
There was no needle position signal during rotation of
the main shaft.
Check the potentiometer (needle position sensor).
3A1 There is abnormality in thread trimming driver. Check the joint card.
3A6
ATH knife retractable position has become nonuni-
form.
Check the position of ATH movable knife.
3A8 Error signal of thread holding driver was detected. Replace the head card.
3B1 No input signal is given when performing serial input
Check the output of the external device.
Check the cable connection.
3C1
Contact error of the bar switch or start/stop switch,
breakage of the switch harness, or bad connection of
the connector
Check the connector and the connecting terminal.
Replace the limit switch or switch assembly.
3D1 Backup battery voltage has decreased.
Turn on the power supply of the machine and charge the bat-
tery.
Set parameters and input designs again.
3D3 There is abnormality in power supply.
Check the wiring. If there is no abnormality, replace the trans-
former.
B01
Floppy disk format has an error.
Format the floppy disk.
Use a new formatted floppy disk.
Read/write error occurred.
Copy other designs to a new floppy disk and dispose of the old
floppy disk.
B02 Floppy disk management information has an error.
Copy the floppy disk, and do not use the floppy disk in which
error occurs.
B03 The write protect window of the floppy disk is open. Close the write protect window.
B04 No floppy disk has been inserted. Insert a floppy disk.
BC1
Selected design is not found on the floppy disk.
No design is registered on the floppy disk.
Select other design.
BC2
The set file name has already been used for the design
registered in the floppy disk.
Change the file name.
BC4
Design was not written from the memory to floppy
disk correctly.
Retry writing.
Code No. Stop Factor Corrective Action
(GC02)