2.2 Installation of CPU
The motherboard provides a Single Edge Contact(SEC)slot for a Pentium II processor packaged in an SEC
cartridge. Follow these steps to install Pentium II CPU:
Mount the Universal Retention Mechanism (URM) & Insert the Pentium II CPU:
( The illustration is just
for reference )
This URM was designed to accommodate 3 types of CPU Form Factor. ( SECC, SECCII & SEPP ). For
Example : Pentium II & Celeron family.
Note : Please put a soft pad under M/B before the installation of URM.
Installation for SECC CPU :
1.
Leave space below each mounting hole for the fastener to protrude through the hole.
2.
Position URM on the M/B next to the slot1 connector.
3.
Push down retainer pin into respective fastener to secure URM onto the M/B.
4.
Push CPU into URM to contact with slot1.
5.
Make sure latching portion of CPU engaged with windows ledge of URM.
Installation for SECC II or SEPP CPU :
1.
Same as step (1) of SECC.
2.
Same as step (2) of SECC.
3.
Same as step (3) of SECC.
4.
Same as step (4) of SECC.
5.
Snap in 2 clips into side windows of URM to secure SEPP CPU.
If there is a fan on the CPU, Please plug in the fan cable to the three pin fan connector on the motherboard
(CPUFAN).
2.3 Installation of Memory
P2BXB-V
motherboard has 3x168-pin 64-bit Dual Inline Memory Module(DIMM)sockets divided into 3
banks. You can install 3.3V Extended Data Output(EDO)or Unbuffered Synchronous
DRAM(SDRAM)memory. This will increase the system reliability.
2.3.1 Installation of 168-pin DIMM (Dual Inline Memory Module)
1.
Before inserting the DIMM, make sure the pin1 of the DIMM matches with the pin1 on the DIMM socket.
2.
Insert DIMM into the DIMM sockets at a 90-degree angle and press down.
2.3.2 Removal of 168-pin DIMM
1.
Press the holding clips on both sides of the socket outward to release the DIMM.
2.
Gently pull the DIMM out of the socket.