Tait TOP, Руководство по программированию и обслуживанию

Страница: 7 / 86

M2259-00-200-812 Service Information
7
Copyright TEL Encrypted Radio Programming and Service Manual
1 Service Information
1.1 Servicing Accreditation
The procedures described in this manual should only be carried out by service personnel trained
and accredited by Tait Electronics to service Tait Orca Portable (TOP) and T2000 product ranges.
1.2 Tools Required
Use only tools specified for TOP and T2000 radios in their service manuals, including:
„ Fine tipped (1-2mm) temperature controlled soldering iron
„ Tweezers
„ Solder and flux pen
„ Scissors
„ Stainless steel spike (TOP only)
„ #6 Torx drive screwdriver bit (TOP only)
„ Adjustable spanner
„ Pozidrive screwdrivers (T2000 only)
1.3 Warnings
The encryption module controls the radio PTT, and either during normal operation or while
programming, can cause the radio to transmit. Always provide protection for test equipment
(such as RF signal generators) so they cannot be damaged by transmitter power.
Each encryption module is provided with a sheet for recording programmable settings. As some
module settings cannot be read back, it is strongly recommended that all settings be recorded for
each fitted module and kept in a secure place.
1.4 Anti-Static Bench Set-Up
An anti-static bench
set-up is required to
service Tait
equipment, to
prevent static
damage to
components: metal
framed bench, fitted
with a conductive
rubber bench mat
connected by an
earth lead to ground
(c/w 1M series
resistor). The
technician should
wear a wrist strap
connected to the
table.
to building earth (not
mains earth) via
1M series resistor
conductive rubber bench mat
conductive wrist strap
metal frame