4
T02-00004-0201/T02-00004-0202 Horn Speaker
© Tait Limited April 2013
2 Run the receptacle end of the flying lead to the radio power cable and install the two
receptacles in the power connector, as described below.
3 Insert the flying lead receptacles into the power connector socket, as shown below.
T02-00004-0201 horn speaker (25W radios)
■
Insert the wire with the white stripe (positive) and receptacle into the position nearest to
the red wire.
■
Insert the black (negative) wire and receptacle into the position nearest to the black wire.
T02-00004-0202 horn speaker (30-50 W radios)
Tait recommends using insertion tool M81969/18-02 (Tait P/N 355-00001-00).
■
Insert the wire with the white stripe (positive) and receptacle into position 3.
■
Insert the black (negative) wire and receptacle into position 2.
4 To connect the horn speaker, plug the flying lead into the extension cable. To discon-
nect the speaker, release the locking mechanism and unplug the flying lead.
Switching between the Horn Speaker and a Remote Speaker
The horn speaker and the remote speaker (TMAA10-03 or TMAA10-06) cannot be used
simultaneously. If it is desired to switch audio between the horn speaker and a remote
speaker, use a double-pole double-throw switch with a current rating of at least 2A.
More Information
Refer to your radio provider for more information about this product.
power
connector
flying lead
connector
s
speaker –
+13.8V
(red)
ground
(black)
power connector
flying lead
connector
speaker – (to pin 2)
s (to pin 3)
+13.8V
(red)
ground
(black)
power connector
rear view
b
e
d
c
SPKR +
SPKR –
+
