6
ADJUST LIQUID CONTROL
On each side of the deck are two liquid channels. These have different sizes
and should be chosen depending on the liquid (viscosity) and the coil/power.
For example, for MTL vaping at low power and 50/50 liquid, it is enough to o-
pen only the small channel. With a viscous liquid (high VG), it is advisable to
open the large liquid channel. When vaping with a high power (> 15 watts) or
for DL vaping, both liquid channels should be open, so that always sufficient
liquid can flow.
If the atomizer tends to dry (dry hit), the liquid supply should be increased.
If the atomizer tends to become too wet (bubbling), the liquid supply should
be reduced.
By turning the tank, the opening in the evaporator chamber/bell can be moved.
Liquidcontrol closed
(filling/transport)
Small liquid channel opened
Both liquid channel opened
Large liquid channel opened
WARNING
•
Never vape with completely closed liquid supply.
•
Make sure there is sufficient supply of liquid for higher performance.
8. CLEANING
Do not use cleaning agents as they could harm the o-rings.
Before assembling, check the completeness and positioning of the o-rings to prevent leakage of liquid.
• Disassemble the device into its components.
• Clean the components (not the cotton) with warm water or in an ultrasonic bath.
• Completely dry the components before reassembling the device.
9. MAINTANANCE
• Wait until the device has completely cooled down before disassembling, to prevent burns.
• Make sure that there is no power supply by unscrewing the device from the mod or by switching off the mod.
ASSEMBLING DEVICE
• The device is usually delivered fully assembled, the following instructions are for the assembly after cleaning.
Moistening the sealing rings with liquid makes the assembly easier.
!
2
1
3
4