Tahoe T../MA-BTB series, Руководство по установке

Страница: 2 / 24

1
TABLE OF CONTENTS
Preinstallation Instructions for Dealer
Specifications
Cycle Sequence Settings
Softener System Setup (programming)
Bypass Valve Description & Diagrams
Installation
Installer Settings
Hardness, Override, Regen Time & Time of Day
Normal Operating & Error Displays, Power Loss
Low Salt Warning & Resetting It
Start Up Instructions
Replacement Parts & Valve Repair
Front Cover, Drive Assembly and Piston
Injector Assembly & Refill Port Assembly
Drain Line 3/4" Assembly & Flow Controls
Drain Line 1" Assembly & Flow Controls
Water Meter & Bypass Valve
Installation Fitting Assemblies & Service Wrench
Control Valve Servicing
Troubleshooting Procedures
PREINSTALLATION INSTRUCTIONS
This unit has a control valve which enables the setting of not only the length of each regeneration cycle but
also the order in which cycles (steps of regeneration) occur. The following pages instruct how to set the
treatment unit’s sequence of cycles, cycle times, salt dose, exchange capacity, and gallon
capacity/regeneration time. A salt warning option may also be included.
THE DEALER...
1. Read this page,
GENERAL INSTRUCTIONS, INSTALLER SETTINGS, NORMAL, OPERATING
DISPLAYS,
and
LOW SALT WARNING.
2. Complete the
CYCLE SEQUENCE SETTINGS.
3. Complete the
SOFTENER SYSTEM SETUP.
a. Cycle Times
b. Choose Softener or Filter
c. Set Salt Dose
d. Set Capacity
e. Set How Gallon Capacity Will be Calculated
f. Set Regeneration Time Option
g. Select or Turn Off Low Salt Warning
THE INSTALLER..
.
1. Read Bypass Valve page.
2. Read
GENERAL INSTRUCTIONS, NORMAL OPERATING DISPLAYS,
and
RESETTING LOW
SALT WARNING
(if applicable).
3. Be sure
CYCLE SEQUENCE SETTINGS
and
SOFTENER SYSTEM SETUP
are done before leaving for
installation.
4. Follow
INSTALLATION INSTRUCTIONS, INSTALLER SETTINGS, TIME OF DAY,
and
RESETTING
SALT AMOUNT
(if applicable).
5. Follow
START UP INSTRUCTIONS
.