Taga Harmony TTA-1000, Инструкция по эксплуатации

Страница: 8 / 16

8
Rear Panel:
6. Phono Ground Screw
7. Analog Stereo RCA Inputs PHONO / LINE / CD
8. Preamplifer Stereo RCA Output
9. Speaker Right Channel Output (Speaker Connectors)
10. Speaker Left Channel Output (Speaker Connectors)
11. Power Cable Input and Fuse Box
Note! A blown fuse should be only exchanged for exactly the same type as
indicated on the rear amplifier panel. The Power Cable should be disconnected!
Hooking Up Speaker Cables
The Speaker Connectors can accommodate up to 10AWG speaker cables as well
as most of popular plugs (banana etc.). A 10AWG cable is recommended for longer
connections (longer than 20 meters / 66 feet). For shorter lengths you can use 12/14
or 18 AWG cables. It is recommended to leave about 150 cm (5 feet) of extra cable
at the amplifier end to facilitate positioning and installation of the amplifier. Do not use
staples, nails or other metal objects to secure the cables. You will get the best sound
quality and least amount of hum by keeping the cables away from other electrical wires
and cables.
Pay attention to connecting the polarity of the amplifier correctly with the speakers
in each speaker group (speakers should be connected RED + with RED + amplifier
connector, BLACK – with BLACK – amplifier connector).
For 8 ohm speakers connect RED+ to the Speaker Connectors marked with the “8Ω” mark.
For 6 ohm speakers connect RED+ to the Speaker Connectors marked with the “8Ω” mark.
For 4 ohm speakers connect RED+ to the Speaker Connectors marked with the “4Ω” mark.
Before connecting make sure that your amplifier is turned off.
Please refer to your speaker instruction manual for more information.
Front and Rear Panel