15
Bluetooth®
is a registered trademark of Bluetooth SIG, Inc.
We reserve the right to change the technical data and the design of the product without notice as a result of further development.
Specifications
Break-In
Your TAGA Harmony amplifier sounds great immediately after it is taken out of the
carton but as all hybrid amplifiers, this amplifier requires a “break-in” period to reach its
full sonic capabilities.
During the “break-in” period it is recommended to operate the amplifier at moderate
volume levels.
The first level of the “break-in” is reached after approximately 10 hours of play.
The optimal level of the “break-in” is reached after approximately 40 to 60 hours of play.
It is recommended to avoid one-time short periods of operation unless the amplifier
reaches the first “break-in” level. When the amplifier is turned on, it should operate for
around 4-6 hours.
Turn off procedure
Make sure to turn off the amplifier first when powering down your system.
Note:
If the amplifier was turned off even for a short period of time, you should wait
at least 2 minutes before turning it back on. Do not turn it ON then OFF and then ON
again in quick succession.
Follow this procedure each time you turn your amplifier OFF / ON. This precaution will
minimize the stress (high voltages) on internal components.
Vacuum Tube Replacement
The lifetime of vacuum tubes may vary and depends on their operation time and
ambient temperature, playback volume levels and the number of on and off cycles.
Note:
The warranty time for vacuum tubes is shorter than for other components of this
device - for more details check your warranty terms or contact a local dealer.
Replacement vacuum tubes are not supplied with this product.
Note:
The vacuum tubes are installed inside the device and should be replaced only by
qualified service personnel.
Additional information
Power Output:
2 x 150W, 8ohm, Class A/B
Vacuum Tubes:
2 x 12AX7; 2 x 12AU7
THD:
Less or equal 0.1% (1kHz 1W)
Signal/Noise ratio:
90dB
Frequency Response:
20Hz – 20kHz (+/- 0.5dB)
Inputs:
Analog:
RCA Stereo: CD, Line,
Phono (MM/MC)
Digital:
USB (for computer), Optical
Outputs:
RCA Pre-Out
Connectivity Wireless:
Bluetooth® v4.0
Headphones:
Impedance 32-320Ω,
Output Power 1W 160Ω
Phono input
(MM | MC):
Input impedance
47KOhms/120pF | 100ohms/120pF
Gain 40dB | 60dB
Output voltage 300mV
@ 1kHz – 3mV (MM) 0.3mV(MC)
THD SNR 83dB | 70dB
USB Supported Data:
Asynchronous 32bit / 384kHz
Texas Instruments PCM-5100
AC Power,
Power Consumption:
230V 50Hz, 450W
Dimensions (HxWxD):
14.2 x 43 x 38 cm
Weight (net):
16.5 kg / pc
