remote control
21
remote control
20
channel
standby
dvd and av
control
The 100x5R allows for switching individual channels into power
saving standby mode. This is beneficial when replaying two
channel stereo without surround sound enhancement (such as
TAG McLaren Surround).
To provide this function certain buttons need to be operated in
combination. When pressed, the button marked ‘
channel -
amp
’ will, after a time delay of one second switch all five
channels between in and out of standby as described above.
Alternatively if you press the button ‘
channel - amp
’ followed
(within 1 second) by ‘
1
’, ‘
2
’, ‘
3
’, ‘
4
’ or ‘
5
’ then only that
channel will toggle in and out of standby.
To allow the user to switch several modules together in or out of
standby press ‘
channel - amp
’ immediately followed by any
sequential combination of numbers.
The 100x5R remote control allows the convenient control of the
major functions of the TAG McLaren Audio av processor AV32R
and the dvd player DVD32R.
unit / system
standby
amp - dvd - av
all
The 100x5R is provided with a ‘
standby
’ mode. This function
will switch off the power supplies of the amplifier module. The
control section of the 100x5R remains active to monitor the
status of the 100x5R and to wait for a ‘wake-up’ command from
the remote control.
Pressing ‘
standby amp
’ key of the remote control, will ‘wake-
up’ the 100x5R. The 100x5R runs through the start up procedure
which takes approximately 10 seconds before the unit is finally
un-muted.
For those channels of the 100x5R which are switched to standby
mode the individual channel LED will be extinguished. Only the
active channel LEDs are illuminated.
The remote control also allows you to switch the five channel
amplifier 100x5R (
amp
), the dvd player DVD32R (
dvd
) and the
av processor AV32R (
av
) in and out of standby.
Pressing the button labelled ‘
all
’
(1)
will switch all three
products in and out of standby mode.
1. This function will only work if all 3 products receive the command synchronously
(ie all products must either be in standby or out of standby). If a product has
gone out of synchronisation, use its individual standby button to bring it back
into synchronisation.
photoshop100x5R Use Man 11/1/01 3:50 pm Page 20
