Connecting to a firmware server
You can also enter the IP address of a Firmware Server.
To enter the IP address of a firmware server, press Enter a second
time after entering the IP address of a Sun Ray Server. You will
then get an
Enter Firmware Server IP:
prompt.
NOTE:
The Firmware Server is included in the 10 IP
address total that you may configure.
After you have entered the information for your servers,
you are prompted with a
Save Changes
screen. Select
Yes or No as appropriate. If you select Yes, you are
given a confirmation screen stating "
Changes saved.
" as
shown below.
Figure 4-3: Changes saved screen
Selecting No at the
Save Changes
screen or selecting Ok
at the
Changes saved
screen returns you to the Main
Menu.
When you exit the Main Menu via Exit or pressing the
Esc, the COMET will reset/reboot. The changes you
entered will take effect on the reset.
Chapter 4
Configuring
COMET
COMET User’s Guide
59
Configuring COMET
Servers
Содержание COMET15
