3
4.
Set lock type
Connect Jumper
JM1
according to type of lock you using. (See picture)
Jumper
JM1
is placed on the right side at the middle of the Electric board
Jumper mode
lock type
Jumper on two top pins
Magnetic lock
(Normally close)
Jumper on two button pins
Electric lock
(Normally open)
5.
Before Installation
Install the lock and prepare the wires infrastructure:
1.
Two wires from the power supply.
2.
Two wires to the lock.
3.
Two wires from a telephone exchange free extension.
4.
2 wires from optional bypass pushbutton (if installed).
Assemble the wires through the hole on the back box of
Tador Doorphone.
Mark the four drill points of the back box on the wall.
Drill and install the back box to the wall.
Make sure the AC adapter is unplugged.
Connect the wires to the Electronic circuit using the captions on the PCB and using the
electric diagram (refer to page 10).
