Tadiran Telecom Swift Inverter 9U, Руководство по обслуживанию

Страница: 19 / 115

17
5. “SILENCE” button
* Set silence on or off(the characters of silence will appear or disappear)by pressing
this key.
* Once energized, the unit will be defaulted to be silence off.
6. “TIMER”button
* On the status of the unit on, press this button to set timer off. On the status of the
unit off, press this button to set timer on.
* Press this key once, words H on (off) will appear and flicker. In which case, press
button to adjust time (press
“
/
”
button to adjust time (press / value
quickly), the setting time range is from 0.5 to 24 hr. ; press this key once again to fix
the time, then remote controller will send out the signal immediately and H on/off will
stop flickering.
* If the time of that no press timer button under flickering status is above 10s, the
timer setting will quit.
* If the timer has been set, press this button once again to quit it.
7.“HEALTH” button
* Press this button, you can turn on or off the health function.
8.“SLEEP” button
* Press the SLEEP button, the sleeping indicator light of indoor unit flashes on.
* The air-conditioner runs in sleeping mode for 10 hours and quit sleep mode, recover
back to former mode.
* The unit will turn off automatically if the timing mode are running out of time.
Note: press the MODE or ON/OFF button, the remote controller clears sleeping mode
away.
9.“iFEEL” button
* Press this button can be used to set the feeling function. The LCD shows the actual
room temperature when the function set and it shows the setting temperature when the
function cancelled.
* This function is invalid when the appliance at the Fan mode.
10.“DISPLAY” button
* In display mode, press button once, shut off display, press it again, LCD will show
ambient & setting temperature after flashing 5s.
It's convenient for users who are not adapt to noctilucence and it's also convenient for
checking ambient&setting temperature anytime.
11.“iCLEAN” button
* When remote controller is at the off state, press “iCLEAN” button, the unit runs
“iCLEAN” function .
* The purpose of this function is to clean dust on evaporator and dry the inside water
of evaporator and to prevent the evaporator going moldy due to water deposition and
boasting strange smell.
* After setting “iCLEAN” function, press “iCLEAN” button or “ON/OFF” button to
quit it.