Tadiran Telecom Aeonix T200M Series, Руководство пользователя

Страница: 216 / 316

Station Telephony Features 202 T200M Series User Guide (Coral IPx / FlexiCom)
Speed Dialing: Private Library
3. The Library number (e.g.:
PRIVAT LIB 7000
) appears on the top line of the display. The Library contents appear on the
second line of the display.
NOTE!
Use the table on page 200 to write down your Coral Private Speed Dial numbers (default Private
Library numbers are 7000 to 7009, these may differ in your system, see your system administrator
for your system’s Private Library numbers).
4. Dial the digits you would normally dial to place the call (include outside line access code). Insert required dial parameters
in between the dialing digits when needed. These parameters appear over pages on your phone display. Press the relevant
soft key when needed. The list of dial parameters is given below:
NOTES! Possible outside line access codes are: trunk number, trunk group number, dial service, routing
access or another public/private library number.
The number of digits that can be programmed, including Codes and Pause (time delay), is limited
by the system (defined system-wide). Should you try entering a longer digit string than allowed,
the system will give the error message LENGTH EXCEEDED, and programming will stop.
[Ext#]
External telephone number . Choose this to program or change an external number in the required Library
number. Dial the required external number. Press SPKR to save your entry, or
[Next]
or
[Prev]
to save this
number and select a new library number.
[Next]
Next is used to view the next Library number.
[Prev]
Previous is used to view the previous Library number.
[Canc]
Cancel is used to delete the Library contents.
After entering the outside access code, when entering digits into the Library number, you may also enter any
one of these special dial codes in between the digits to enhance dialing:
[Dly] [x sec]
Time Delay (seconds) where x =1 to 9: Introduces a delay of x seconds before the following digits are dialed.
[Code] [End]
Final Digit (stop dial). Indicates to the system to stop dialing the outside number (display shows ‘.’).