Tadano electronic LOAD MOMENT INDICATOR system
TADANO AML-C monitors outrigger extended length and
(AML-C) including:
automatically programs the corresponding "RATED LIFTING
Control lever lockout function
CAPACITIES" table
Boom position indicator
Outrigger state indicator
Operator's right hand console includes transmission gear
Boom angle / boom length / jib offset angle / jib length / load
selector and sight level bubble. Upper console includes
radius / rated lifting capacities / actual loads read out
working light switch, roof washer and wiper switch
Ratio of actual load moment to rated load moment
emergency outrigger set up key switch,
indication
jib equipped/removed select switch, eco mode switch,
Automatic Speed Reduction and Slow Stop function
high speed hoist (main/aux) switch
on boom elevation and slewing
and air conditioning control switch. Slewing lock lever.
Working condition register switch
Load radius / boom angle / tip height / slewing range
preset function
NOTE: Each crane motion speed is based on unloaded
External warning lamp
conditions.
Tare function
Fuel consumption monitor
Main hoist / auxiliary hoist select
Drum rotation indicator (audible and visible type) main and
auxiliary hoist
CARRIER SPECIFICATIONS
TYPE
- Rear engine, left hand steering, driving axle 2-way
SUSPENSION
- Front: Rigid mounted to frame.
selected type by manual switch, 4x2 front drive, 4x4 front and
Rear: Pivot mounted with hydraulic lockout device.
rear drive.
FRAME
- High tensile steel, all welded mono-box construction.
BRAKE SYSTEMS
- Service: Air over hydraulic disc brakes on
all 4 wheels. Parking/Emergency: Spring applied-air released
TRANSMISSION
- Electronically controlled full automatic
brake acting on input shaft of front axle. Auxiliary: Electro-
transmission. Torque converter driving full powershift with
pneumatic operated exhaust brake.
driving axle selector. 6 forward and 2 reverse speeds, constant
mesh.
TIRES
- 29.5-25 34PR(OR)
3 speeds - high range - 2 wheel drive; 4 wheel drive
3 speeds - low range - 4 wheel drive
OUTRIGGERS
- Four hydraulic, beam and jack outriggers.
Vertical jack cylinders equipped with integral holding valve. Each
TRAVEL SPEED
- 22 mph (36 km/h)
outrigger beam and jack is controlled independently from cab.
Beams extend to 23' 11-3/8" (7.3 m) center-line and retract to
AXLE
- Front: Full floating type, steering and driving axle with
within 10' 10-1/2" (3.315 m) overall width with floats. Outrigger
planetary reduction. Rear: Full floating type, steering and driving
jack floats are attached thus eliminating the need of manually
axle with planetary reduction and non-spin rear differential.
attaching and detaching them. Controls and sight bubble located
in superstructure cab. Four outrigger extension lengths are
STEERING
- Hydraulic power steering controlled by steering
provided with corresponding "RATED LIFTING CAPACITIES" for
wheel. Four steering modes available: 2 wheel front, 2 wheel
crane duty in confined areas.
rear, 4 wheel coordinated and 4 wheel crab .
Min. Extension
8' 10-1/4" (2.7m) center to center
Mid. Extension
18' 1/2" (5.5m) center to center
Mid. Extension
21' 11-3/4" (6.7m) center to center
Max. Extension 23' 11-3/8" (7.3m) center to center
Float size(Diameter) 1' 11- 5/8" (0.6m)
ENGINE
Model
Cummins QSB6.7 [Tier 4]
Radiator
Fin and tube core, thermostat controlled
Type
Direct injection diesel
Fan, in.(mm)
Suction type, 9-blade, 28 (711) dia.
No. of cylinders
6
Starting
24 volt
Combustion
4 cycle, turbo charged and after cooled
Charging
24 volt system, negative ground
BoreXStroke, in.(mm)
4.212 x 4.882 (107 x 124)
Battery
2-120 amp. Hour
Displacement, cu. in (liters)
409 (6.700)
Compressor, air, CFM(l /min)
17.0 CFM (481) at 2,400rpm
Air inlet heater
24 volt preheat
Horsepower (kW)
Gross 270 (201) at 2,000rpm
Air cleaner
Dry type, replaceable element
Torque, Max. ft-lb (Nm)
730 (990) at 1,500rpm
Oil filter
Full flow with replaceable element
Capacity, gal.(liters)
Fuel filter
Full flow with replaceable element
Cooling water
7.4 (28)
Fuel tank, gal.(liters)
79.2 (300), right side of carrier
Lubrication
4.0 (15)
Cooling
Liquid pressurized, recirculating by-pass
Fuel
79.3 (300)
DEF
10.0 (38)
3
Содержание GR-800XL
Страница 5: ...GR 800XL WORKING RANGE CHART 5...
Страница 6: ...GR 800XL WORKING RANGE CHART 6...