DANGER
HIGH VOLTAGE
C
AUTION
C
AUTION
C
AUTION
Dangerous Voltages Inside !
No user serviceable parts inside
Do not remove covers
Dangerous internal voltages exceeding
380 Volts
- DO NOT REMOVE COVERS !
Equipment must be installed & serviced
by suitably qualified service personnel in
a restricted access area.
TPS13-3.5DC_RevB.pdf
www.tacpower.com.au
General
The TPS-13-3.5A power supply is designed for
ITE and indoor use only
TPS13-3.5DC model is Dual Channel Switch Mode power supply providing 13.5Vdc at 3.5A continuous load current.
When operating from mains, these models provide an output of 13.5Vdc ( to power connected equipment) and are configured with a
separate battery charging channel. Available battery charge current is 300mA @ 13.5Vdc (total supply output current 3.8A )
Output short-circuit and overload protection are provided . Removal of the fault / short circuit condition will return the power supply
to normal operation ( Auto-Reset ).
The TPS13-3.5DC power supply has been tested to AS/NZS60950.1:2015 electrical saftey and AS/NZSCISPR32:2015 Class B EMC in Australia
by Austest Laboratories which is a NATA accredited laboratory. A certificate of compliance has been issued by SAA Approvals, Certificate
of Compliance SAA203368-EA.
Metal Cabinet Variants
TPS13-3.5DC
Single 3.5A battery charger, supply only - no cabinet (225L x 120W x 60H )
TPS-SMALL KIT
Small steel enclosure ( 250W x 310H x 100D mm ) will house 12V 7AH SLA Battery and 1 PDM
TPS-MEDIUM KIT
Medium steel enclosure ( 340W x 436H x 145D mm ) will house 12V 17AH SLA Battery and 2 PDM
TPS-LARGE KIT
Large steel enclosure ( 480W x 470H x 185D mm ) will house 12V 55AH SLA Battery and 2PDM
All enclosures are supplied with mounitng hardware, tamper switches and battery leads.
Connection
Single Output Models
10-way removable terminal block provides the following:
( S
ee over the page for a layout
)
* 13.5Vdc Output
* 13.5Vdc Charger for SLA (Sealed Lead Acid) Batteries
* AC OK Relay Output
(Relay is NC when mains is OK)
* Battery Fault / Low Battery Relay Output ( SPDT )
(This relay is NO when Battery is OK, going NC when Battery
voltage drops below approx. 10.5V during AC Fail)
Caution when handling batteries:
Exercise care when terminating and connecting batteries. Mishandling or short circuit of SLA batteries can cause severe damage and fire.
