Tactical Electronics UDC 360, Руководство пользователя

Страница: 5 / 16

* Always remove batteries when not in use
• The UDC 360 Under Door Camera is powered by four 3Volt Photo Lithium batteries. Most manufacturers of these
cells designate them as size 123 or CR123A. Tactical Electronics systems draw high current; use only GE SANYO,
ENERGIZER, or DURACELL batteries. Testing has proven those batteries to provide the longest run time in our
products.
• Run times will vary, components in this system are designed to optimize power management and power sharing
when hard-wired together. Usage of IR LEDs will also contribute to varied run times.
• The diagrams below demonstrate proper battery installation and power-up for the UDC 360 Under Door Camera.
» Battery Life Indicator:
The LED power indicator will flash red and green to indicate low
battery power.
As battery life continues to diminish the LED indicator will
illuminate solid red. After the LED illuminates solid red the
unit will shut down within 10 minutes.
When battery life is critical the LED indicator will illuminate
solid blue. Once this occurs the UDC 360 will only remain
ON for 10-15 seconds while the system shuts down to protect
recorded video on the SD card.
» Battery Compartment & Power-Up Procedure:
The UDC 360 (left) requires four 3V Lithium batteries for
operation. Use the battery orientation diagram adhered to the
UDC 360 for reference.
NOTE: For SD card recording, ensure the SD card is inserted
before powering ON the UDC 360.
The power switch for the UDC 360 is a push button located on
the side of the unit. The picture (left) identifies the UDC 360
power button. Fully depress the power button to power ON and
OFF the UDC 360.
Immediately after the UDC 360 is powered ON the LED indicator
will illuminate a solid blue for approximately 8-10 seconds while
the system initializes. Once the power-up phase is complete
the LED indicator will illuminate a solid green indicating full
operational use (If no SD card is inserted, the LED indicator
will flash red).
NOTE: When the UDC 360 is powered ON all IR LEDS are
powered OFF by default.
To power OFF the UDC 360, hold down the power button for 3
seconds to begin power down cycle - when the LED illuminates
blue release the power button and the unit will power OFF
within 5 seconds.
NOTE: DO NOT open the battery door before powering OFF the
UDC 360. Failure to properly power OFF the unit will result in
loss of recorded files.
OPERATION AND SUPPORT PUBLICATION
UDC 360 POWER UP
5
Tactical Electronics & Military Supply
LED indicators