3
3. Rotate the plastic arm vertically, then slide the arm off of its mounting pin
and set aside.
Elevator Arm and Spring Installation
The plastic arm and spring must be installed onto the opposite gimbal (which
doesn’t have the metal throttle ratchet arm).
1. Slide the arm onto the arm mounting post, then rotate the arm downward
over the gimbal.
2. Using hemostats or needle-nose pliers, grasp one loop end of the spring
and hook the opposite loop end of the spring onto the spring tension lever
down inside the gimbal.
3. Pull the spring upward and hook the top loop end onto the elevator arm,
and release.
4. Adjust the spring tension screw until the desired tension exists for the
vertical movement of this stick.
Case Assembly
1. Carefully tuck all cables back inside as when the case was opened.
2. Align the case rear back onto the case front,
making sure that no wires are pinched between the case parts.
Press
the case halves together.
3. Insert the six screws back into their positions and carefully tighten until snug. Do not cross the threads or over-tighten
the screws.
4. Re-install batteries inside the battery compartment and close the battery door. Test all mechanical and electronic changes
for proper operation.
Mode change is complete. Contact Hobby Services if questions as follows:
HOBBY SERVICES
3002 N. Apollo Drive, Suite 1
Champaign, IL 61822
Tel: (217) 3980-3630 (9:00am – 5:00pm CST, M-F)
E-mail: [email protected]
© 2014 Tactic, a Hobbico company
