-7-
D
E
n L
e
e
r
G
de
o
M
en
e
r
G
D
E
L
nge
a
r
O
e
d
o
M
mal
r
o
G
n
d
N
Green Mode
0015e3 Performance Curves
Programming your 0015e3 circulator:
Modify the performance of the circulator as needed by rotating the dial using a flat
screwdriver An orange LED will illuminate when the circulator is powered on. The LED will flash each time a setting is changed.
See diagram below to determine best setting for the system.The selection of the right operating curve depends on the
characteristics of the heating system and the actual heat demand. See cross-reference replacement chart on page 9.
The 0015e3 has 3 Operating Settings:
• LOW - 5 feet of head constant pressure, variable speed.
• MEDIUM - 10 feet of head constant pressure, variable speed.
• HIGH - 18 feet of head max, full fixed speed.
CAUTION:
Do not attempt to remove LED panel from circulator. Serious damage to circulator electronics may result.
ATTENTION:
N’essayez pas de retirer le panneau de LED du circulateur. Des dommages sérieux à l’électronique du
circulateur peuvent en résulter.
Selection options are LOW, MEDIUM or HIGH. On HIGH setting, the 0015e3 runs at full speed. On MEDIUM or LOW setting,
the 0015e3 varies its speed to maintain a constant pressure differential (Δp-c) in the system as heating load increases or
decreases. See chart above for operating curves and equivalent 00® model at each setting.
Green Mode:
• On
LOW setting only
after 12 hours of constant run circulation, the 0015e3 will automatically self-adjust to the
Green Mode
curve for power optimization. See Green mode curve above.
• When the 0015e3 cycles OFF, it always resets to it’s original operating mode setting.
Содержание 0015e3
Страница 10: ... 10 NOTES ...
Страница 11: ... 11 NOTES ...