4. CROSS PULL CUT (SEE FIG H1, H2)
A mitre cut is made at 0° bevel and any mitre angle in the range from 45° left to 45° right. It can be made
as a chop cut.
For most convenient operation, your sliding mitre saw is equipped with mitre detents for fast and
accurate mitre cuts of common mitre angles (Left:G1 45°, 30°, 22.5°, 15°;0°; Right: 0° ,15°, 22.5°, 30°,
45°). The rotary table locking knob (8) is used to lock the table at the desired mitre angle. To adjust the
mitre angle, put the saw on a stable surface and fix it, loosen the rotary table locking knob
(7) counter-clockwise, hold the handle (1) firmly to rotate the saw head to the desired position, then
tighten the rotary table locking knob (7) clockwise.
5. MITRE CUT (SEE FIG I1, I2)
A bevel cut is made at 0° mitre and any bevel angle in the range of 0° to 45° left.
The saw can be moved from the normal 0° perpendicular position to an angled position
down to 45° from
the horizontal, on the left only.
Loosen the bevel lock lever (19) and tilt the saw head to the left, until the desired angle is
reached on
the bevel scale (20). Re-tighten the bevel (19) lock lever and make your cut.
09
