17
SECTION 9—REPLACING OF THE MOTOR, CAPACITOR, SAFETY
INTERLOCK, ON/OFF SWITCH AND FUSE HOLDER CONTINUED:
To Change the On/Off Switch:
1) Follow the directions above to open the Motor Box.
2) Pressing the tabs on the On/Off Switch pull forward and remove it from the case.
3) With the new On/Off Switch near, transfer the wires from the old switch to the new switch making sure
they are installed in the same place.
4) Slide the new On/Off switch back into the Motor Box
5) Follow the instructions below to close the Motor Box.
To change the Fuse Holder:
1) Follow the instructions above to open the Motor Box.
2) Locate the Fuse Holder and remove the wires. Note that the wire marked R1 goes onto the middle tab of
the Fuse Holder while wire marked R0 goes to the tab at the end of the Fuse Holder.
3) Unscrew the old Fuse Holder and replace it with the new Fuse Holder.
4) Replace the wires making sure the wire R1 goes to the middle tab and wire R0 goes to the end tab.
5) Follow the instructions below to close the Motor Box.
To Close the Motor Box:
1) Turn the Motor Box over so that the opening is up.
2) Lower the Perforated Plate onto the Motor Box. Be careful that all the wires are within the Motor Box and
that they will not be pinched when securing the Perforated Plate.
3) Replace and screw in the 4 legs that were previously removed. See Figure 18.
4) Locating the Brake Arm Spring, secure it back onto the Spring Hanger on the Perforated Plate restoring
tension to the Brake Arm Spring. See Figure 17.
5) Turn the machine over to its proper orientation.
6) Replace the Twisting Head Assembly as per the instructions in Section 6.
Figure 17
Brake Arm Spring
Spring Hanger
See Figures 18, 19 and 20 on the next page.
