Trouble shooting
Failure
Cause
Solution
Machine
doesn t work
Q
The number in ball counter has reached 0 and the robot is in
standby mode
Q
The plug has poor contact with the socket
Q
The key on the control box doesn t work due to excessive
shaking
Q
The poke bar in ball container is loose
Q
The ball duct is jammed by foreign objects
Q
There are not enough balls in the container
Q
It takes time to transport the balls from container to shooting
head
Q
The robot doesn t work due to the improper operation of the
control box
Q
The cable connecting to the motor is loose
Q
The thin-film switch of the control box has been broken
Q
There would be dirt and wear on the top-wheel and bottom-
wheel after a long time in operation
Q
The long and short ball sequence mode is selected
Q
The shooting head is deflected by an external force
Q
Clean or replace the friction wheel
Q
Cancel the long and short ball
sequence mode
Q
Cancel the irregular rotation mode
Q
Restart the robot
Q
Fasten the poke bar
Q
Clear away the foreign objects
(see pg ??)
Q
The amount should be 50-100
balls
Q
Wait for a while
Q
Start up again after shut-off for 3
seconds
Q
Connect it using the original
method
Q
Replace the thin-film switch on the
surface of control box
Q
Press the start key
Q
Check the electric socket
Q
Press the switch until the
number displays
Q
Replace the control box
Machine works,
but does not
release the balls
Pressed key
failure
Landing spot is
unstable
1.
Please read the instruction manual carefully before using the robot, and follow the instructions to
operate the robot.
2.
Instructive advice should be given when machine is used by children.
3.
Avoid using outdoors in windy or rainy conditions.
4.
Be careful when connecting and disconnecting the ball collecting net.
5.
When the robot is operating, please do not open the movable door, and don t touch the shooting head
or poke bar.
6.
When the robot is operating, please keep away from the shooting head to avoid harm.
7.
When the robot is operating, if you observe something abnormal, such as smoke coming from the
machine, please stop the robot and unplug it immediately. Repair or service must be performed by a
qualified repair person.
8.
Some parts of the robot will heat up during the operation. Please pay attention to avoid burning
yourself.
9.
Please turn off and unplug the robot after use.
The company has the right to amend the description of products in this manual without and
notice in advance.
Safety issues and regulations
Содержание PP80
Страница 1: ......
