TA Service TA iQ, Руководство по обслуживанию

Страница: 18 / 50

Page 18
ISM BRACKET 1.6
At the front of the tilt, the ISM module is turned around,
so you can get to the plugs from the front.
Remove the front plate (1) and you will have access to
the plugs.
The new tilt has all the cables wired up from the factory,
then you are sure that the cabling is tied up right and
don’t get squeezed, even if you have to change light,
backrest actuator or cable to the controller.
The following cables has been extended to the end of the
tilt. Adding and changing part will be at the plugs at the
tilt and not at the ISM module

Cable for light

Cable for backrest actuator

Controller cable
1. Light – left
2. Light – left
3. NC.
4. Cable to controller
5. Light – right
6. Light – light
7. Backrest actuator
1
1 2 3 4 5 6 7