ASSEMBLY MANUAL – SEARAILS RR-XX – 0-4-0 SYTEAM LOCOMOTIVES
3/30/15
T R Knapp Model Engineering
10
16
Bend resistor leads to form “U”,
and solder to one pole of
motor; trim leads as shown in
photo in step 17
17
Solder one lead from LEDs to
resistor, and one to opposite
pole of motor; make sure there
is adequate separation
between end of resistor and
motor pole. (Note: Unit in this
photo has already been tested
and color-coded per Step 18.)
18
Test again, and mark LEDs for
correct orientation; after
testing, insulate LED solder pads
with CA adhesive, Pacer
Canopy Glue or Gallery Glass
coating.
