FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Toyota LandCruiser 200 Series 2007+
Part No.
070SB13R82A
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia
wide.
File: F-1434.docx
Page 7 of 18
11/12/2013
23.
Position the chassis rail mounting block
in the chassis rail (as shown), through
the rectangular opening.
Ensure the grooves machined into the
chassis rail mounting block align with
the outside walls of the chassis rail &
that the hole is positioned away from
the centre-line of the vehicle.
24.
Apply locktight to one end of the M12 x
1.75 x 280mm threaded rod, then weave
this end through the large hole in the
chassis rail end & secure it into the chassis
rail mounting block that was installed in the
previous step.
25.
Repeat the previous two steps for the
opposite side of the vehicle.
26.
Orientating the chassis rail end spacers as
shown, position them on the end of the
chassis rail, over the studs & threaded rod.
Ensure the fold on the chassis rail end
spacer is positioned away from the
centre-line of the vehicle & that it is
facing forward
.
27.
Lift the chassis mount into position over the
captive studs in the end of the chassis rail &
align it centrally on the vehicle.
RHS SHOWN
RHS SHOWN
THREADED ROD