FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Toyota LandCruiser 200 Series 2007+
Part No.
070SB13R82A
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia
wide.
File: F-1434.docx
Page 17 of 18
11/12/2013
82.
Position the wing brace as shown & secure
it in place at the indicated locations, using
M8 x 1.25 x 25mm hex bolts (6), M8 x
Ø19mm flat washers (12) & M8 nyloc nuts
(6).
83.
Tighten the fasteners installed in the
previous step to the specified torque
settings listed on page 1.
84.
Repeat the previous six steps for the
opposite side of the FPS.
85.
Re-fit the grille back to its original position,
using the O.E. fasteners previously retained.
86.
Re-fit the front plastic cover panel back to
its original position, using the O.E. fasteners
previously retained
.
87.
Re-connect the indicator/park lights.
88.
Position the wing guard as shown & secure it
in place, using the fasteners listed below:
88.1.
M6 x 1.0 x 20mm hex bolts (4), M6
spring washers (4) & M6 x Ø12.5mm
flat washers (4).
88.2.
M8 x 1.25 x 25mm hex bolt (1), M8 x
Ø19mm flat washers (2) & M8 nyloc
nuts (1).
89.
Repeat the previous step for the opposite
side of the FPS.
90.
Secure the number plate to the FPS using
the M5 x 0.8 x 20mm screws (2), M5 flat
washers (4) & M5 nyloc nuts (2).
91.
Place the winch slot cover in place in the
winch viewing hole.
RHS SHOWN
RHS SHOWN
STEP 88.2