T.I.P. PSP 7000 ECO, Руководство по эксплуатации

Страница: 8 / 28

6
General safety information
Please read through these operating instructions carefully and make yourself conversant with the control
elements and the proper use of this product. We shall not be liable in the case of damage caused as a result of
the nonobservance of instructions and provisions of the present operating instructions. Any damage caused as
a result of the nonobservance of the instructions and regulations contained in the present operating instructions
shall not be covered by the warranty terms. Please keep these operating instructions in a safe place and hand
them on together with the device should you ever dispose of it.
Children and other persons not conversant with the contents of these operating instructions must not use this
device. Please keep an eye on children to make sure they will not use the unit as a toy to play with. In various
countries, applicable provisions may be in place which might contain restrictions regarding the age of the user,
and they have to be adhered to in any case.
The device must not be operated by people with restricted physical, sensory or mental capabilities unless they
are either under the supervision of a person being responsible for their safety, or receiving from such a person
instructions as how to use the device, respectively.
Please inspect the device for damage occurred during transportation. In case of damage, the retailer has to be
informed immediately, at the latest within 8 days after the date of purchase.
Please read these instructions thoroughly before using the pump!
Use
Centrifugal pump for submersible usage with resin encapsulated motor.
These stream pumps are intended for the transport of water in a garden pond, a fi sh pond, or a fountain, for
the operation of fi lter systems, steams, and waterfalls, etc., as well as for aeration and circulation of water.
The pump may not be used in or on the side of swimming pools!
Please refer to the type plate for technical specifi cations or the table on page 1.
Safety measures
- Caution! It may only be used in garden ponds and in their protection area if the electrical installations have
been set up to comply with the code’s requirements. Please contact an electrician.
- Before use: Check whether mains connection and plug are intact.
- Mains voltage and type of current have to correspond to the data on the type plate.
-
The pump has to be connected to a regular safety plug socket through a residual current device
(RCD, 30 mA).
- The connection box should be located in a water-protected area. It should be at least 2 m away from
the edge of the pond (see Fig.1).
- Keep the plug dry!
-
Pull out mains plug before starting to work on the pump, fountain or pond.
It is not allowed to run the pump when people are inside the water! (disconnect the pump)
- Important! If the mains connection or the motor housing is damaged, the pump cannot be used anymore.
It cannot be repaired since the connection is cast into the motor housing.
- Never hang up or transport the pump by the cable!
- Operate the pump only when it is immersed in water!
Start up (see Fig. 1)
Important! Do not let the pump run dry. The possibility of damage to the device cannot be excluded in
this case.
- Completely immerse the pump in your pond. In this process water will penetrate into the pump body.
- A minimum water depth of 25 cm is required for underwater operation to avoid the pump taking in air.
-
The maximum depth for submerged operation of the
2 m
pump is 2 m!
- The water temperature should not exceed 35°C.
- The pump must be protected from frost.
- You can switch on the pump by plugging the power plug into the outlet.
- To prevent unnecessary fouling place the pump above the sludge deposits on a stable and horizontal
substrate (stone slab), in your pond!
- You can connect accessories on the threaded connections of the pump.
GB