T.I.P. Cross Tools CSC 350-2000 PRO, Перевод оригинальной инструкции по эксплуатации

Страница: 21 / 28

Translation of original operating instructions
6
Noise emission and vibrations
Values measured in accordance with EN 61029-1:2009 and EN 12418:
Sound pressure level:
•
Idle speed: L
pA
77 dB(A), uncertainty K
pA
=3 dB(A)
Sound power level:
•
Idle speed: L
WA
90 dB(A), uncertainty K
WA
=3 dB(A)
The vibration level determined in accordance with EN 61029-1:2009 is suitable for a comparison of power tools. It can
also be applied for a preliminary assessment of vibratory stresses.
The vibration level represents the main applications of the power tool. If the tool is used for different applications, with
different insert bits or with inadequate maintenance, the vibration level might differ. In this case, vibratory stresses dur-
ing the whole working period can increase significantly.
For an accurate assessment of vibratory stresses, those periods must also be taken into account during which the tool
is turned off or is running without being used. In this case, vibratory stresses during the whole working period can de-
crease significantly.
Operators should be protected against vibrations by additional safety measures like: regular maintenance of the tools,
keeping their hands warm and appropriate organization of operating sequences.
5. Setup
5.1. Assembly
1. Read the manual carefully before assembly. Clean the work area.
2. Take the tool out of the box,
3. Installation and assembly of machine is described in sections 5.2 to 5.6.
4. Check PRCD safety switch
– as described in 5.7.
5. Pay attention to other notes in 5.8 and 5.9.
5.2. Installation of motor unit
1. The machine is supplied without the motor unit mounted on it.
Install the motor unit on the frame in accordance with the installation instructions
provided
2. Then install the partition disc in accordance with the instructions in chapter 6.
Installing the toggle (Fig. 4)
1. Remove toggle nut from accessories bag and install it underneath in accordance
with instructions.
2. Then screw the toggle nut included in the scope of delivery for the toggle (2) onto
the thread.
3. Now a button (3) can be unscrewed and removed from one end of the toggle and
then installed in the toggle nut (3) Then the tommy head (1) can be tightened
back down again.
4. Now, with the tommy nut loosened, turn the motor head until the desired angle
of intersection is reached, then secure the toggle firmly. (see working note 7.2)
5.3. Setting up the machine (Fig. 5)
1. Follow the work instructions as shown in Fig. 5.
2. Lift stone-cutting machines by handle on their left side, fold out the foot (1) and
lock it in position.
3. The machine is now lying on one side on the installed rollers with the other side
supported on the pre-assembled foot (1). Refer to section 5.6 for the rollers that
have not yet been installed.
4. Now lift the other side of the machine, fold out the foot (2) and secure it firmly.
5. Please check that the legs on which the machine stands are deployed correctly
for a firm stance.
6. For transport, perform steps 1 to 4 in reverse order.