16
> Self-Installation Guide
17
> Glitel GT–318RI DSL modem
Launching the modem’s configurator
Insert the enclosed CD into your computer’s
drive. If the content does not open
automatically, launch the
START.EXE
programme
from the CD’s main directory.
Select
“Inštalácia DSL internetu”
from the
main menu and then
“Inštalácia modemu
Glitel GT-318RI”
. After you go through all
the steps of your installation guide, click
“Spustiť inštaláciu”
.
A window is displayed after the configuration
software is launched. Enter first the test login
and password provided on page 18 in section
Internet – Internet Connection Functionality
Check. The test login and password must
be inserted in the modem. The login and
password provided by your Internet access
provider (ISP) should be entered only after
you have tested the functionality of the DSL
connection. Click on “Uložiť nastavenia” to
save your login and password in the modem.
Testing the Correct Connection
Telephone – telephone/digital line functionality check
The dialling tone should be heard from the receiver of your telephone/fax. Try to make a call
and check the quality of sound in the receiver. If you installed the device correctly, the quality of
sound did not change compared to the pre-installation state.
Possible problems:
■
the dialling tone is not heard
■
disturbing sounds (noise, crackling) are heard from the receiver
■
calls cannot be made from the telephone
Telephone line outages may occur during the DSL installation; the digital line may be functional
only 1 minute after the NT was connected to the splitter. If these faults have not disappeared
after a repeated check of the connection carried out according to the Guide, contact
our Fault
Reporting Centre 12129
.
Modem – Checking the DSL Connection’s Functionality
Check the status of the indication controls on your modem and compare their status with the
description. The modem should be in a hibernating mode.
PWR
– glows, if the modem is connected to the power supply
DSL
– glows if the modem is synchronised with the DSL line
ACT
– flashing during data transmission, glowing in the hibernating status
LAN
– glows if the network interface is active
Possible problems:
■
no control glowing on the modem
■
status of controls not corresponding to hibernating status of the modem
■
PC did not detect modem
