T+A DVD 1240 R, Руководство пользователя

Страница: 36 / 40

36
Trouble-shooting
Many problems have a simple cause and a corres-
pondingly simple solution. The following section des-
cribes a few difficulties you may encounter, and the
measures you need to take to cure them.
If you find it impossible to solve a problem with the help
of these notes, please disconnect the unit from the mains
and ask your authorised
    specialist dealer for advice.
Problem: Machine does not switch on (green
LED stays dark).
Cause: Mains lead not connected correctly.
Remedy: Check connection, push in firmly.
Problem: Machine does not respond when
buttons are pressed.
Cause:
Static discharge or powerful interference
(e. g.
lightning) have affected the
processor’s memory.
Remedy: Reset machine : disconnect the mains
plug, wait about 10 seconds, then plug in
again. Switch the machine on.
Problem: Machine responds correctly when front
panel buttons are pressed, but cannot
be remote-controlled via an 'R' series
pre-amplifier, integrated amplifier or
receiver.
Cause 1:
Batteries in remote control handset
exhausted or fitted incorrectly.
Remedy: Fit new batteries, or re-fit batteries with
correct polarity.
Cause 2: R
LINK
or RC plug not connected correctly
to machine’s R
LINK
or RC socket.
Remedy: Complete connections as shown in wiring
diagram; push connector in firmly.
Cause 3:
No visual contact between remote control
transmitter and remote control receiver of
the
'R' series pre-amplifier, integrated
amplifier or receiver.
Remedy:
Ensure direct visual contact between
remote control transmitter and receiver
(glass doors may prevent contact).
The maximum range of the remote control
system is about 8 metres.
Position the remote control receiver so
that it is not subjected to direct sunlight or
excessively bright lighting. Fluorescent
lamps and energy-saving bulbs are
powerful sources of interference.
Cause 4: The DVD player is not selected as current
listening source on the pre-amplifier,
integrated amplifier or receiver, i. e. the
control commands from the handset are
being passed to another
'R' system
device.
Remedy: Press the     (or     - see next
point) on the remote control handset, and
try again.
Cause:5:
The remote control address of the DVD
player (
AUX or CD ) does not correspond
to the selected audio input sockets on the
pre-amplifier,
integrated amplifier or
receiver.
Remedy: The ' R
LINK
2
nd
ADDR.' switch on the back
panel can be used to configure the DVD
player either as
AUX or CD . You must
then select the appropriate input sockets
(see
'Back panel connections' ).
Problem: Loud hum from the loudspeakers.
Cause: Cinch plugs making poor contact, or faulty
Cinch lead.
Remedy: Check all connections and connecting
leads carefully.
Problem: No sound, or distorted sound.
Cause:
Audio connection to amplifier or TV set not
correct.
Remedy: Complete the connections as shown in the
wiring diagram; push connectors in firmly.
Select a different listening source to check
the amplifier.
Problem: No sound signal via the digital output.
Cause 1: Digital plug not connected correctly to the
digital output socket on the machine.
Remedy: Complete connections as per wiring
diagram; push connectors in firmly.
Cause 2:
Digital output switched off.
Remedy:
Switch the digital output on using the
SETUP menu.
Cause 3: The data format of the selected audio
channel (e. g. Dolby Digital or DTS) is not
recognised by the decoder connected to
the system.
Remedy: Use a decoder which supports the data
formats.