Syzygy SLF800, Руководство по эксплуатации

Страница: 9 / 18

5
SYZYGY | Operating Instructions
PAIRING YOUR SYZYGY SUBWOOFER
WITH THE WIRELESS TRANSMITTER
(Pictorial)
Transmitter front-Panel LED
Press Here to Pair
Bottom of Transmitter
Transmitter front-Panel LED
Press Here to Pair
Bottom of Transmitter
What do the blinking LEDs mean on Subwoofer and Transmitter?
Slow Blink = Not paired
Fast Blink = Searching for connection
Solid Glow = Paired (connection established between transmitter and subwoofer
TIP! The wireless transmitter and subwoofer should
be no more than 50´ (15 m) apart in the room and
there should be no obstacles (i.e., walls, large
furniture, room partitions, etc.) between the devices.
This wireless transmitter is designed for use only with
a Syzygy brand subwoofer. It is not compatible with
any other subwoofer brand.
WARNING! Keep the transmitter out of range
of a microwave oven or any other device
operating on the same frequency.
MODEL NOTE: Syzygy Subwoofer Model
SLF 800 requires the WRM RX1 transmitter for
wireless operation, transmitter sold separately.
Steps to Pairing:
1 Plug in subwoofer.
2 Press and release the ‘Pair’ button on the wireless subwoofer.
The LED should blink rapidly indicating that it is in ‘pairing’ mode.
3 Press and release the ‘Pair’ button on the wireless transmitter.
The LED should blink rapidly indicating that it is also in ‘pairing’ mode.
4 Wait for the solid glow of LEDs on both devices to confirm that a connection
has been established.
TIP! Eight (8) Syzygy subwoofers can be linked to the wireless transmitter.
Simply repeat the above procedure to add each subwoofer separately.
What Do I Do If Pairing Fails?
1 Check to make sure that subwoofer and wireless transmitter are no farther than 50´ (15 m) apart.
2 Check to see that there are no physical obstacles between devices that might be interfering with the signal.
3 Check to see that the signal is not being affected by other appliances operating on the same frequency.
4 Unplug transmitter and subwoofer from power source at the wall.
5 Plug transmitter and subwoofer back in.
6 Repeat steps 2 through 4 in “Steps to pairing” above.